Fuel return/feed/bottleneck fix reference image

[hondaeater]

This is just a reference picture that i drew up...if their are any mistakes please let me know but this is to the best of my knowledge...btw it is using the ptp queasy

[Boostn]

Looks good to me. Only thing I would do differently is use stainless line to connect to the pump. Alot of guys have problems with gas corroding the outside of the 5/16 rubber because most of it isn't ment to have fuel on the outside.

Also you could dump the return line into the filler neck. So you don't have to buy PTP parts.

[hondaeater]

i did it that way so that the return fuel would go back to the pump for cooling purposes....but hopefully it'll help some people out

[Tweekssrt4]

I had a question about the boost reference line. I'm running the AGP hardpipes right now and don't have the nipple for the red line anymore and was curious if I really need to have that boost reference line hooked or not and if so where else would be a good place other than the hardpipe?
I bought the whole AGP returnline kit and PTP Queasy and trying to get my whole fuel system setup since I need to install new 255 pump in my tank and will have a spare fuel canister to mess with for the bottleneck fix.