last night's timeslips

[PreStagedSRT]

Shoulda run gamblers last nite, my car was very consistent, but slow :(
Mods that count are 225/50/15 DR's, Maxxfab/Borla tbe, aem sri, stg 1, sts, mm inserts and agp trans mount.

Launching at 3250 rpms with minimal wheel spin and Im shifting the car hard enough to spin the dr's 1-2, and as hard as i can 2-3 and 3-4 without wot shifting. Boost leak maybe? Why is the car so slow?

60' - 2.109
330 - 5.955
1/8 - 9.082
MPH - 79.52
1000 - 11.843
1/4 - 14.142
MPH - 99.47


60' - 2.008
330 - 5.930
1/8 - 9.104
MPH - 79.43
1000 - 11.847
1/4 - 14.151
MPH - 97.75

60' - 2.079
330 - 6.006
1/8 - 9.133
MPH - 79.84
1000 - 11.851
1/4 - 14.132
MPH - 99.05

I also took a video of the red sled running a 10.14 i think @ 135ish mph, ill post that up when i get the camera back

[spoolin05srt]

hey at least its consistant...

[Nolimits]

Are you wheelhopping when the tires spin? Drag radials are known for hardcore wheelhop unless you have full mounts (both motor AND tranny mounts) and very damaging to the axles and oil pan.

And even then, your times suck but your potential always shows in your trap speed, and a 99mph trap speed is something that a stock SRT-4 does. You have a power loss somewhere down the line.

[SRT4Trb0]

WOT shifting all the way down helps a very good amount...but very consistant

[Evolution IX]

Definitely check for boost leaks. What are your plugs gapped at? Your times are on par if not slower then a BONE STOCK SRT. Good job on being consistent though.

[PreStagedSRT]

plug gap i believe is .040 ill check that when i get to my laptop (im borrowing a computer right now). Wheel hop is almost nonexistant. Tomorrow im gonna leak check the car after work if i dont pass out during the day. I have stage 2 w/o sitting on my workbench at home and a bigger turbo on my shopping list... we'll see if that helps any.

[SPECJ]

i dont see a WGA or boost controllers in that mix at all. You certainly arent going to make much more power off just and exhaust and intake. You could have a boost leak. You arent really making any MPH between the 1/8th and 1/4. The wheel spin from the DR's could have cause the knock sensor to pull some timing

[whitemboid]

i have the same mods as you and im consitent 13.9-14.1 at 101-104mph

[mr_eh]

wouldnt his boost gauge indicate a boost leak?

[SuperMario]

wouldnt his boost gauge indicate a boost leak?

:slap: